How To Install A Frameless Lazy Susan

HI,
thanks for the reply. I do have loftier spot identified via a laser level. I cannot fasten anything to the floor as it's new porcelain tile, wall to wall. So now nailing/screwing to floor is possible. I'm not sure I can actually use a construction adhesive either, only for now I digress on the fastening part. I understand what you lot're thinking and was kind of headed in that management anyway.
not sure why no sides were ordered , but I tin make em up

This is very small kitchen. If I am standing in the centre of the room, facing where the sink base goes and go around the room clockwise from Fifty to R the layout is:

24 base cab
30 in oven
36 corner lazy susan #1
5 in filler
39 in sink base of operations (should be centered nether window according to plans)
9 in base cab
two in filler
36 in corner lazy susan #2
dishwasher 24 in
xv in base cab (this is the high point)

that's it. (except for the usual ... old house, corners not square, walls not plumb etc etc, which I fully expected

So I'm thinking I demand to commencement with the sink base centered under the window and
work out to the susans at each corner, essentially placing the susan's Final.
Then align them properly so the faces as properly plumb and they meet the
adjoining cabinets on that wall where the window is.
After that I take the break on each reverse wall (Fifty and R with the stove and dishwasher)
And then, the 24 and 15 in base cabs on the ends.

Does sound reasonable?

Assuming so, that still leaves me with the problems I am having with these lazy susans in getting them both level and plumb. I take only tried one and am going to attempt the other.
Only as I said in my prior post, when I get it level, it's way out of plumb (like 1/4" from bottom of cabinet face, just above toe kick to the tiptop of the face up.

When I have the sides plumb, Running a level across from the cleat I have on the wall for countertop to the 'tip' of the inverted 'V' ie. the corner ^ it's level, but then it drops away as I head out to the edges of the cabinet face up where I need to mate it to the adjoining cabinet. I can't have information technology this mode because that loftier indicate will snap the counter acme , right?

If I and then level the susan so that information technology's level all the way across the top face frame out to the cleat, then my plumb is mode off (which I also can't take as the faces of the 2 cabinets won't mate then.

And so i'm kind of screwed here either way. I don't call back I'm missing annihilation or doing something incorrect.

Lamentable for the lengthy reply

Whatsoever thoughts on this are profoundly appreciated?

Source: https://www.doityourself.com/forum/carpentry-cabinetry-interior-woodworking/592494-lazy-susan-nightmare.html

Posted by: currierbied1942.blogspot.com

Share this post